Home batteries · UK · Guide
Home battery installers: how to choose one you can trust
A home battery is only as good as the person who wires it in. How to find a certified installer, what their quote should contain, and the paperwork that proves the job was done properly.
Key facts
- MCS’s installer search lets you filter for battery storage and check that a firm is certified.1
- To finance a battery through the Warm Homes Loan scheme, both the installer and the product must be MCS certified.2
- A Warm Homes Loan quote must be dated within the last six months, itemised, and show the installer’s MCS number and the system size.2
- Installed batteries are zero rated for VAT until 31 March 2027, then reduced rated.3
On this page
Choosing well takes four steps. Use the MCS search to find installers certified for battery storage near you, and check any firm you are offered against it.1 Ask for an itemised quote that names the battery, its usable capacity and the installer’s MCS number. Make sure the installer handles the network notification. And if you want to finance the job through the government-backed Warm Homes Loan, an MCS installer and an MCS-certified product are compulsory.2
It matters because this is the person who cuts into your consumer unit and connects a box holding a lot of stored energy to your home’s wiring. Whether you can borrow for it, and whether the paperwork holds up when you need it, depends on that person being properly certified.
Our verdict: treat MCS certification as the minimum, not a recommendation. Then choose between certified installers on the clarity of their quote.
Why MCS certification matters
MCS is the UK’s quality mark for renewable energy systems such as solar panels and heat pumps, and battery storage is one of the technologies it certifies installers for.4,1 MCS sets out what you should expect at every stage of an installation and publishes a Customer Commitment that lists your rights.4 Certification is also the gateway to money: MCS certification is a requirement for many UK government incentives.4
For batteries, the most important of those is the Warm Homes Loan. To be financed under the scheme, a battery must be an MCS-certified product, installed by an MCS-certified installer to the MCS standard for that technology.2 The installer must be certified for that specific measure at the time of installation.2
How to use the MCS search
- Go to the MCS Find an installer tool and search by location.1
- Filter for Battery Storage, and add solar panels if you want both fitted at once.1
- Shortlist two or three firms and ask each for a survey and written quote.
- If someone contacts you first, or a firm is recommended to you, use the same tool to check that it is certified for the technology you are buying.1
What a good quote includes
The Warm Homes Loan rules give a useful checklist even if you are paying cash. For a loan, the quote must:2
- be dated within the last six months;
- be addressed to you, on the company’s headed paper;
- include the installer’s MCS number;
- show the full installation address;
- itemise the cost of every part of the work;
- show the system size in kW.
For a battery, a typical quote may also include connecting it to your existing solar panels, setting up the monitoring app or control system, and fitting isolators, breakers or protection devices.2
Add your own questions to that list:
- Which battery, and how much usable capacity? Compare usable kWh, not the total on the box.
- Is backup included? Many systems need an extra device to keep circuits running in a power cut; the Powerwall 3, for example, uses Tesla’s Backup Gateway 2.5
- What are the warranty conditions? Some depend on an internet connection: the full Powerwall 3 warranty does.5
- What VAT rate is applied? Installed batteries are zero-rated until 31 March 2027, then subject to the reduced rate from 1 April 2027.3
Our solar battery cost guide explains how to compare prices and work out payback.
The network paperwork
A home battery counts as a generating unit for your network operator, so it has to be notified or approved.6 Take SSEN’s area as an example. There are two routes:
| Size | Route | What the installer does |
|---|---|---|
| Up to 3.68 kW per phase | G98 | Installs, then notifies the network operator within 28 days of commissioning7 |
| Larger, up to 32 A (7.36 kW) per unit | G99 fast track | Applies before installing, waits for confirmation, then has up to 3 months to install and 28 days to confirm commissioning6 |
Even a small system needs an application first if there is more than one generator at the property, which can be the case when a battery joins existing solar panels.7 SSEN aims to reply to fast-track applications within 10 working days.6 Larger systems may need an export limit set up to keep what flows to the grid within agreed levels.6
Battery hardware is built for this: the Powerwall 3, for instance, lists compliance with the G98, G99 and G100 standards.5 A good installer handles the application and tells you which route applies before you sign; if yours hasn’t, ask.
Warning signs in a quote
Measured against what a lender has to see, these should make you pause:2,1
- no MCS number on the quote, or a number the MCS search cannot find for battery storage;
- a single lump-sum price with no breakdown of the battery, inverter, backup and labour;
- no system size in kW;
- a quote more than six months old, or not addressed to you;
- no answer on who notifies the network operator.
A firm that cannot produce a quote a lender would accept is unlikely to produce the paperwork you need later either.
After the installation
For loans, the installer must lodge the completed job in the MCS Installation Database, which generates an MCS certificate.2 Ask for the certificate whether or not you are borrowing, and keep it with your house documents along with the warranty registration and the network operator’s confirmation.
Paying with a Warm Homes Loan
The scheme runs through participating lenders, not the government directly. It is for owner-occupiers and private landlords anywhere in the UK, with no income test; the lender makes its usual checks.2 Batteries qualify on their own or with solar panels, with a loan cap of £15,000 for each.2 An EV charger can be included as part of a battery installation, but not on its own.2 Our Warm Homes Plan explainer covers how the rate reduction works.
Our verdict
Shortlist only MCS-certified battery installers, ask every one for the same itemised quote, and favour the firm that explains the network route and the warranty conditions without being asked.1,2 If you are still choosing the battery itself, read our guides to solar batteries, home battery storage and the Tesla Powerwall 3.
Products compared
EcoFlow
EcoFlow STREAM 5000
Price: No published price
EcoFlow STREAM 5000: Where to buy: uk.ecoflow.com
as of · ecoflow.com
Show all 3 ▸
GivEnergy
GivEnergy All in One
Price: No published price
GivEnergy All in One: Where to buy: givenergy.com
as of · givenergy.com
GivEnergy
GivEnergy All in One (Gen 1)
Price: No published price
GivEnergy All in One (Gen 1): Where to buy: givenergy.com
as of · givenergy.com
| Product | Capacity | Weight | Warranty | Price |
|---|---|---|---|---|
EcoFlow STREAM 5000 |
5,024 Wh capacity1 | 45.4 kg1 | 10 years1 | No published priceEcoFlow STREAM 5000: uk.ecoflow.com |
GivEnergy All in One |
13.5 kWh usable2 | – | 12 years2 | No published priceGivEnergy All in One: givenergy.com |
GivEnergy All in One (Gen 1) |
13.5 kWh usable2 | 173.7 kg2 | 12 years2 | No published priceGivEnergy All in One (Gen 1): givenergy.com |
All data
| Product | Capacity | Solar input | AC power | Cycles | Size | Weight | Protection | Warranty | Grid | Noise | Charging power | Backup power |
|---|---|---|---|---|---|---|---|---|---|---|---|---|
| EcoFlow STREAM 5000 | 5,024 Wh capacity1 | 5,000 W solar input, 4 MPPT1 | 3,000 W AC output off grid1 | 10,000 cycles1 | 295 × 489 × 298 mm1 | 45.4 kg1 | IP651 | 10 years1 | 800 W / 3,000 W grid-tied AC output1 | below 30 dB1 | – | – |
| GivEnergy All in One | 13.5 kWh usable2 | – | – | – | 1100 × 600 × 280 mm, 173.7 kg2 | – | IP652 | 12 years2 | – | under 30 dB2 | 6 kW continuous, 7.2 kW peak, AC-coupled2 | Whole-home backup with a Gateway2 |
| GivEnergy All in One (Gen 1) | 13.5 kWh usable2 | – | 6.0 kW continuous, 7.2 kW peak; AC-coupled2 | – | 1100 × 600 × 280 mm2 | 173.7 kg2 | IP652 | 12 years2 | – | – | – | – |
Specifications come from each maker's own product page or datasheet, taken on 14 NOV 2026. Our picks are editorial judgement from those published specs, not test results; we haven't tested the products. – means the maker publishes no price.
Calculators
Home battery payback and sizing calculator
How much a battery saves a year with your tariff, how long it takes to pay back, and what size fits.
Pre-filled from: Ofgem
Open the calculator
Example figures · Electricity the battery supplies a year · as of 14 November 2026 10 kWh 930–1,380 kWh
Rules and grants in force
Temporary zero rate of VAT on installed heat pumps, solar panels and batteries
HM Revenue & Customs
0% as of
Installed energy-saving materials, including heat pumps, solar panels and batteries, have a temporary zero rate of VAT until 31 March 2027, after which the reduced rate applies.
Official source gov.uk
Updated · against gov.uk
Warm Homes Loan scheme
GOV.UK
up to £35,000 as of
Government-backed loans for home energy upgrades, offered by participating lenders to owner-occupiers and private landlords across the UK; the first consumer phase began in September 2026. A government grant to the lender reduces the interest rate on loans of three years or more. Loan caps are £15,000 for solar panels, £15,000 for a battery (on its own or with solar), £20,000 for an air-to-water heat pump and £35,000 for a ground source heat pump, the heat pump caps before the Boiler Upgrade Scheme grant is deducted. Air-to-air heat pumps cannot be financed yet, because MCS has no standard for them. Products and installers must be MCS certified.
Official source assets.publishing.service.gov.uk
Updated · against assets.publishing.service.gov.uk
Dated rule changes
-
in 134 days
VAT on installed heat pumps, solar panels and batteries rises to 5%
The 0% rate on installed energy-saving materials ends on 31 March 2027; from 1 April 2027 they carry the reduced rate of 5%.