EV chargers · UK · Comparison
Hypervolt EV charger: the Home 3 Pro from its spec sheet
The Hypervolt Home 3 Pro is a solar-friendly home EV charger with an unusually long cable option and its own earth-fault protection. Here is what the spec sheet means for your drive.
Key facts
On this page
The Hypervolt Home 3 Pro is a 7.4 kW tethered charger for single-phase homes, with a solar-only Super Eco mode, a solar-and-grid Eco mode, and a choice of 5, 7.5 or 10 m cable.1 It has built-in PEN fault protection, so it can go onto a standard PME supply without an extra earth rod.2
That makes it a natural fit for a house with panels on the roof. When the sun is out and the meter is exporting power for a few pence, the charger can soak up the surplus and turn it into free miles, and the long cable and the missing earth rod help on awkward drives.1,2
Our verdict: buy it if you have solar panels and either a long drive or a tight installation budget for earthing work. If you have three-phase power, or you want the most established solar charger, look at the myenergi zappi.
The Home 3 Pro at a glance
- Power: up to 7.4 kW on a single-phase supply, at a maximum of 32 A.1
- Cable: tethered, with a Type 2 connector or Type 1 for older cars, in 5, 7.5 or 10 m lengths; the 10 m cable is Type 2 only.1
- Charging modes: Boost, Eco (solar and grid) and Super Eco (solar only).1
- Load management: automatic load management, which reads a CT clamp at the incoming supply.1,2
- Connection: 2.4 GHz Wi-Fi and Bluetooth.1
- Build: 328 × 243 × 101 mm, rated IP66 against water and dust and IK10 against impact, for wall or pole mounting.1
- Climate: works across the temperature range in the datasheet.1
- Regulations: built to the Electric Vehicles (Smart Charge Points) Regulations 2021.1
How the solar modes work
The same clamp does two jobs. Fitted at the point where electricity enters the house, it measures the whole home’s load and detects any solar power being exported.2 The charger uses that reading to keep the house under its supply limit and, in the solar modes, to match charging to the surplus.
Super Eco uses solar power only. Eco uses solar and tops up from the grid. Boost charges at full speed, whatever the source.1 The zappi’s ECO+ and ECO modes are the closest equivalents: ECO tops up from the grid when the surplus falls below 1.4 kW, and ECO+ pauses until spare solar returns.3
In winter, when there is little surplus, the deciding factor is the tariff. At the capped average rate for October to December 2026, a big charge at home gets expensive.4 British Gas’s EV Power tariff, for comparison, has a much cheaper rate in its window after midnight, which brings the cost of the same charge well down.5 Our comparison of the best EV tariffs shows the current off-peak rates.
Earthing and installation
The Home 3 Pro has integrated PEN fault protection, compliant with Amendment 2 of BS 7671:2018, so it can connect to a PME (TN-C-S) supply with no additional earth rod.1,2
A few installation details are worth knowing before you book:
- It has an internal 6 mA DC residual current device, but needs external AC protection: a Type A RCD is recommended, and Type AC devices must not be used.1,2
- Overcurrent protection comes from an external MCB or RCBO of 32 A or 40 A. The charger draws just under 32 A, so a 32 A device can run hot and trip on long sessions. Ask for 40 A.1,2
- It must be fitted by a suitably qualified electrician, and the unit must be registered as installed within 48 hours to validate the warranty.2
- If your network operator asks for a lower maximum current, the installer can fix it in the settings.2
Our guide to installing an EV charger at home covers the survey and the network paperwork step by step.
How it compares
Hypervolt Home 3 Pro
Buy it with solar panels and a long drive or a tight budget for earthing work.
- Power on single phase
- 7.4 kW
- Cable
- Tethered: 5, 7.5 or 10 m
- Solar modes
- Eco (solar and grid), Super Eco (solar only)
- Connection
- Wi-Fi, Bluetooth
myenergi zappi
Look here instead for three-phase power or the most established solar charger.
- Power on single phase
- 7.4 kW; 22 kW on three-phase
- Cable
- Tethered 6.5 m or untethered
- Solar modes
- ECO (solar and grid), ECO+ (pauses without spare solar)
- Connection
- Wi-Fi, Ethernet
Ohme Home Pro
Connects over 4G, so it suits weak Wi-Fi where you park; the solar modes are weaker.
- Power on single phase
- 7.4 kW
- Cable
- Tethered 5 m; 8 m optional
- Solar modes
- Solar Boost in the app
- Connection
- 4G SIM
| Hypervolt Home 3 Pro | myenergi zappi | Ohme Home Pro | |
|---|---|---|---|
| Power on single phase | 7.4 kW1 | 7.4 kW; 22 kW on three-phase6 | 7.4 kW8 |
| Cable | Tethered: 5, 7.5 or 10 m1 | Tethered 6.5 m or untethered6 | Tethered 5 m; 8 m optional8 |
| Solar modes | Eco (solar and grid), Super Eco (solar only)1 | ECO (solar and grid), ECO+ (pauses without spare solar)3 | Solar Boost in the app8 |
| Connection | Wi-Fi, Bluetooth1 | Wi-Fi, Ethernet6 | 4G SIM8 |
| Weather and impact rating | IP66, IK101 | IP65, IK107 | IP5511 |
| Size (H × W × D) | 328 × 243 × 101 mm1 | 438 × 282 × 122 mm7 | 170 × 200 × 100 mm11 |
Each cell cites its source.
Against the zappi, the Hypervolt is smaller, offers the longer cable, up to 10 m against 6.5 m, and has the higher water rating; the zappi adds Ethernet, a three-phase 22 kW option and an untethered version.1,6,7 Against the Ohme Home Pro, the Hypervolt has the stronger solar modes, while the Ohme connects over 4G and comes with standard installation in its price from £999.8
Every one of them meets the same legal baseline: default charging hours outside 8am to 11am and 4pm to 10pm on weekdays, a randomised start delay you can cancel, and charging that carries on if the internet drops.9
Do you need Wi-Fi where you park?
The Home 3 Pro connects over 2.4 GHz Wi-Fi and Bluetooth LE.1 Fit it where the Wi-Fi signal is good.2 If the connection drops, the charger must still charge the car: the regulations require every smart charger to keep working without its network link.9 You lose the scheduling and the solar matching until it reconnects, so a weak signal is worth fixing with a mesh point or a cable run before the charger goes up.
Is there a grant?
Only if you rent, own a flat, or have only on-street parking. The renters and flat owners grant pays 75% of the cost, up to £500, until 31 March 2027, and needs an OZEV-authorised installer and an eligible chargepoint model.10 Check that the model you want is on the eligible list before you apply. Our guide to the EV charger grant covers the details.
Who should buy the Hypervolt Home 3 Pro
- Solar owners on single-phase power who want a solar-only mode without paying for three-phase capability.
- Long or awkward drives, where the 10 m cable saves moving the charger or the car.1
- Homes where an earth rod would be difficult, such as a fully paved driveway.2
Look elsewhere if you have three-phase power (the myenergi zappi), if your Wi-Fi is weak where you park (the 4G Ohme EV charger), or if the look of the charger on the front of the house matters most (the Andersen EV charger).6,8
Work out your charging costs with the EV charging cost calculator, and see the full field in our best home EV chargers.
Calculators
EV charging cost calculator
What home charging costs a year, against public charging and an EV tariff, and when a charger pays back.
Pre-filled from: Ofgem
Open the calculator
Example figures · Charging cost a year · as of 14 November 2026 8,000 miles £547–£668 a year
Rules and grants in force
Energy price cap, 1 October to 31 December 2026
Ofgem
26.32 p/kWh as of
Ofgem's price cap for October to December 2026 puts a typical dual-fuel bill paid by direct debit at £1,723 a year, 4% higher than the previous quarter. Electricity is capped at 26.32p per kWh with a standing charge of 54.83p a day; gas at 7.97p per kWh with a standing charge of 29.68p a day. Ofgem will announce the cap for January to March 2027 by 25 November 2026.
Official source ofgem.gov.uk · ofgem.gov.uk · ofgem.gov.uk
Updated · against ofgem.gov.uk
EV chargepoint grant for renters and flat owners
GOV.UK Find a grant
up to £500 as of
Renters and flat owners can get 75% of the cost of a home chargepoint, up to £500 per socket. The scheme closes on the date given in the source unless it is renewed.
Official source find-government-grants.service.gov.uk
Updated · against find-government-grants.service.gov.uk
Dated rule changes
-
in 44 days
New energy price cap period begins Intended
Ofgem will announce by 25 November 2026 the price cap level for the period from 1 January to 31 March 2027.
-
in 133 days
Chargepoint grant for renters and flat owners closes
The grant of 75% up to £500 per socket closes at 23:59 on 31 March 2027 unless it is renewed.