EV chargers · UK · Comparison
myenergi zappi EV charger: the solar charger, explained
The myenergi zappi is the charger people with solar panels tend to end up with, and for good reason. It is also bigger than most rivals, has more parts to fit and does more than many drivers need.
Key facts
On this page
On a bright May afternoon, the panels on the roof can make far more electricity than a house running a fridge and a router will ever use, and the surplus flows out to the grid. The Smart Export Guarantee pays for that exported power at whatever rate your supplier chooses, as long as it is above zero.3 A charger that diverts it into the car instead turns it into miles you did not have to buy at the capped rate.4 That is the job the zappi was designed for.
The short answer: the myenergi zappi is a smart charger with three modes, two of them built around solar. ECO+ charges only from surplus solar; ECO blends solar with a small grid top-up; FAST charges at full power.2 It runs at up to 7.4 kW on a normal single-phase supply or 22 kW on three phase, comes tethered or untethered, needs no earth rod, and costs from £779 including VAT.1
Our verdict: if you have solar panels, the zappi is the charger to beat. Without them, you are paying for features you will not use, and a smaller, cheaper-to-install charger makes more sense.
The three charging modes
The modes are the reason to buy a zappi. The differences between them are small, and they decide where your car’s power comes from.2
- ECO+ sends only surplus solar to the car: power that would otherwise be exported. If the surplus falls below the minimum the car can accept, charging pauses.
- ECO charges from a mix of surplus solar and the grid. It keeps the charge going by taking a minimum of up to 1.4 kW from the grid when the solar surplus falls short.2
- FAST charges at the maximum available rate, from any source. Without solar, this is how the zappi behaves like any other charger.
The zappi works out the surplus with clip-on grid sensors supplied in the box, and it can work alongside a home battery.2 Charge scheduling is built in, so on a winter evening with no sun you can set it to run on your off-peak tariff hours.2 It is designed to work with a time-of-use tariff.1
Specifications that matter
- Power: 7.4 kW on single phase or 22 kW on three phase, if the car can take it.1
- Cable: tethered with a 6.5 m Type 2 cable and an integral holster, or untethered with a locking Type 2 socket.1,2
- Earthing: built-in PEN fault technology, so no earth rod is required.1
- Surge protection: built in, with a separate surge protection device fitted by the installer for compliance.1
- Connection: built-in Wi-Fi and an Ethernet port; it can be hard-wired with a CAT5 or CAT6 cable.1,2
- Display: a backlit graphical LCD.2
- Open protocol: OCPP 1.6J, through myenergi’s cloud.2
- Build: 438 × 282 × 122 mm, IP65 and IK10, for indoor or outdoor mounting, working from −25°C to 40°C out of direct sunlight.2
- Load balancing: optional, to limit the current drawn from your supply.2
- Warranty: 3 years as standard.1
The zappi is designed and manufactured in the UK.1
What the installer needs to know
A zappi installation has a few more parts than a basic charger, and a good quote will mention them.
- Grid sensor. The clip-on current sensor goes round the incoming supply cable to measure import and export; it handles up to 100 A and a cable up to 16 mm across.2 A second sensor can monitor solar generation on a single-phase supply.2
- Surge protection. The installer fits a separate surge protection device for compliance.1
- Internet. Built-in Wi-Fi, or a CAT5 or CAT6 cable to the Ethernet port if the router is out of range.1
- Supply. Single-phase 230 V, or three-phase 400 V for the 22 kW rating.2
A qualified electrician can usually fit it in a few hours.1 Ask for the sensor position and the surge device to be itemised, so you can compare quotes fairly.
The zappi with a home battery
The zappi is designed to work alongside a home battery system.2 With panels, a battery and a zappi on the same roof, ask the installer how surplus solar will be shared between the car and the battery, and how to change it. Our Tesla Powerwall 3 page and the solar battery cost guide cover the battery side.
How it compares
myenergi zappi
With solar panels, the charger to beat; without them, you pay for features you won’t use.
- Power
- 7.4 kW single phase; 22 kW three phase
- Solar-only mode
- ECO+
- Cable
- Tethered 6.5 m or untethered socket
- Connection
- Wi-Fi and Ethernet
- Price
- From £779 inc. VAT
Hypervolt Home 3 Pro
Smaller than the zappi, with a longer cable choice of up to 10 m.
- Power
- 7.4 kW single phase
- Solar-only mode
- Super Eco
- Cable
- Tethered 5, 7.5 or 10 m
- Connection
- Wi-Fi, Bluetooth
- Price
- –
Ohme Home Pro
Connects over 4G and includes standard installation in its £999 price.
- Power
- 7.4 kW
- Solar-only mode
- Solar Boost in the app
- Cable
- Tethered 5 m; 8 m optional
- Connection
- 4G SIM
- Price
- From £999 with standard installation
| myenergi zappi | Hypervolt Home 3 Pro | Ohme Home Pro | |
|---|---|---|---|
| Price | From £779 inc. VAT1 | – | From £999 with standard installation6 |
| Power | 7.4 kW single phase; 22 kW three phase1 | 7.4 kW single phase5 | 7.4 kW6 |
| Solar-only mode | ECO+2 | Super Eco5 | Solar Boost in the app6 |
| Cable | Tethered 6.5 m or untethered socket1 | Tethered 5, 7.5 or 10 m5 | Tethered 5 m; 8 m optional6 |
| Connection | Wi-Fi and Ethernet1 | Wi-Fi, Bluetooth5 | 4G SIM6 |
| Warranty | 3 years1 | – | 3 years6 |
Each cell cites its source.
Against the Hypervolt Home 3 Pro, the zappi’s advantages are the three-phase option, the untethered version and the Ethernet port; the Hypervolt is smaller and has a longer cable choice.1,5 Against the Ohme Home Pro, the zappi’s solar modes are more complete, while the Ohme connects over 4G and comes with standard installation in its £999 price.6 See our pages on the Hypervolt EV charger and the Ohme EV charger.
All three meet the same legal baseline: default charging hours set outside the weekday peaks of 8am to 11am and 4pm to 10pm, a randomised start delay you can cancel, and charging that continues if the internet connection drops.7
What it costs to buy and fit
The zappi starts at £779 including VAT.1 That is the charger; a qualified electrician then has to fit it, and the price of that depends on the cable run, your consumer unit and whether your network operator needs to be told before or after. Get a fixed quote after a survey. Our guide to installing an EV charger at home explains what pushes installation costs up.
Renting, or own and live in a flat, with off-street parking? You may qualify for the government grant of up to £500: see our EV charger grant guide.8
Who should buy a zappi
- Solar owners. ECO+ is the cleanest way to put surplus generation into the car, and it is the reason the zappi exists.2
- Homes with three-phase power and a car that can charge at 22 kW.1
- Weak Wi-Fi but a cable to hand: the Ethernet port gives a wired connection.1
Skip it if you have no solar and no plans for any. A simpler charger does the overnight job for less, and our best home EV chargers comparison covers the field. Whichever charger you choose, the tariff decides most of the running cost: compare the best EV tariffs and use the EV charging cost calculator. Thinking about adding panels? Our plug-in solar guide covers the smallest systems.
Calculators
EV charging cost calculator
What home charging costs a year, against public charging and an EV tariff, and when a charger pays back.
Pre-filled from: Ofgem
Open the calculator
Example figures · Charging cost a year · as of 14 November 2026 8,000 miles £547–£668 a year
Rules and grants in force
Energy price cap, 1 October to 31 December 2026
Ofgem
26.32 p/kWh as of
Ofgem's price cap for October to December 2026 puts a typical dual-fuel bill paid by direct debit at £1,723 a year, 4% higher than the previous quarter. Electricity is capped at 26.32p per kWh with a standing charge of 54.83p a day; gas at 7.97p per kWh with a standing charge of 29.68p a day. Ofgem will announce the cap for January to March 2027 by 25 November 2026.
Official source ofgem.gov.uk · ofgem.gov.uk · ofgem.gov.uk
Updated · against ofgem.gov.uk
Smart Export Guarantee
Ofgem
Under the Smart Export Guarantee, some electricity suppliers, known as SEG Licensees, must pay small-scale low-carbon generators for electricity they export. Each SEG Licensee sets its own rate, contract length and other terms; the rate must always be above zero. Your installation must be in Great Britain and meet the scheme's eligibility criteria.
Official source ofgem.gov.uk
Updated · against ofgem.gov.uk
Dated rule changes
-
in 44 days
New energy price cap period begins Intended
Ofgem will announce by 25 November 2026 the price cap level for the period from 1 January to 31 March 2027.